There's a length of two core that carries the live from the top switch down to the bottom one and back to where it is connected to the red.įor the switching to be on the live side, the black incoming will be connected to the white of the three core - which again should be sleeved (or wrapped in black tape). The white in the two core feed in the ceiling again goes to the white of the fan. When regular two core is used for the run to the switch, the white should be sleeved black to indicate that it is also hot.įor this, the white in the three core is used to take the feed down to the two switches, and the red and black carry the two switched feeds back, these would then be connected to the live feeds into the fan (they're usually black and blue, and should have tags indicating which is which). With a single load, typically a further two core would be used to carry the live out to the switch and back, by wire-nutting the two together (or using a spare terminal on the light fixture, and thw switched return and the white neutral would then go to the light. The two core plus ground is the incoming feed to the light fixture. The question is what wires from the ceiling box are hooked to what wires on the ceiling fan? The new fan has four wires and I know that the blue is the light: The bottom switch has a set of wires coming in from the top that are: Carefully lift the glass up to the fan and turn clockwise until the glass is snug. White - Hooked to White on top AND to top of switch Plug the light into the fan, then screw in the mounting ring and the light with three keyhole screws.White - Hooked to White on bottom AND to top of switch.The top has a set of wires coming into the switch box on the top and bottom: The top switch controls the fan and the bottom switch controls the lights. There are two separate light switches (they are not side-by-side as you'd expect, but are top and bottom and are about six inches or so apart. 3-wire cable (switch legs) from first ceiling outlet, down to a 2-gang box for the first set of switches for ceiling fan / light control. After engaging all the wires, push them back in the bracket and put the faceplate up. I also tested them flipping the switches. If your ceiling fan does not have lights, the same step will be applied. So I have two sets of wires coming into the ceiling box. I am sure that electrical standards vary place to place I am in the United States specifically Michigan. I know I screwed up, but now it is a learning opportunity. I messed up and forgot to take a picture of the wiring. So I am replacing my bedroom ceiling fan.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |